Sakura Tissue-Tek TEC 6 - Page 43

5. Troubleshooting
43
Descriptions of Additional Codes
Additional code Description (Applicable location)
01 Cooling plate (Cryo Module)
02 Parafn chamber (Embedding Module)
03 Left side warming chamber (Embedding Module)
04 Right side warming chamber (Embedding Module)
05 Left side hot plate (Embedding Module)
06 Right side hot plate (Embedding Module)
07 Parafn line (Embedding Module)
08 Dispensing solenoid valve (Embedding Module)
09 Dispenser (Embedding Module)
10 Forceps holder (Embedding Module)
11 Hot plate heater
21 Set value data
22 Operation status data
23 Dispensing log data
24 Error log data
25 Temperature record data
Buzzer Notication
This instrument noties the following events with a buzzer sound.
Type of notication Notication sound Condition for notication How to stop
Startup notication Short beep The display has started after the
power was turned on. (Approx. 15
seconds later)
Stops automatically.
Start notication Short beep The TEC 6-EM is operating. Stops automatically.
End notication Short beep Auto operation has ended. Stops automatically.
Error notication
(Caution)
One-minute continuous
beep
A caution-level error occurred Stops automatically or by
toughing the “
” (stop) button.
Error notication
(Warning)
Continuous beep A warning-level error occurred.
Touch the “
” (stop) button.
NOTE:
The buzzer notification cannot be disabled. The volume of the
buzzer is fixed.