Salamander Pumps CT Series

Other manuals for Salamander Pumps CT Series

Installation And Warranty Guide32 pages

Questions and Answers

Q
qschultzAug 3, 2025
Why is my Salamander Pumps CT Water Pump not starting?
- A
  Amanda FordAug 3, 2025
  Your Salamander Pumps Water Pump might not start due to several reasons: * Insufficient gravity flow: Verify the pump's suitability for your setup, ensuring it's not in a negative head installation. Check that the inlet filters are not blocked and that the flow rate meets the minimum requirement of 2l/min on both hot and cold water supplies. * Incorrect inlet/outlet connections: Make sure the connections are plumbed correctly and all valves are open. * Electrical issues: Check the power supply, fuse, and circuit breaker. * Debris under the flow switch: Remove the outlet hoses to check that the flow switch is in its lowest position. * Float sticking in the outlet: Ensure there's no debris in the outlet area.
R
Robert ParrishAug 16, 2025
Why is Salamander Pumps CT Water Pump noisy?
- M
  Michaela ClarkAug 16, 2025
  A noisy Salamander Pumps Water Pump can be attributed to: * Air in the system: Refer to the instructions for dealing with air in the system. * Pump vibrating on the surface: Ensure the rubber feet are fitted to the pump. * AV couplers causing vibration: Check that all AV couplers are straight and not bent or distorted.
T
thompsonleeAug 21, 2025
What to do if Salamander Pumps CT Water Pump starts with all outlets closed?
- R
  Robert OrtizAug 21, 2025
  If your Salamander Pumps Water Pump starts when all outlets are closed: * Check for leaks in the system. * Ensure all outlets are fully closed or capped, and there are no dead legs in the pipework.
B
Brooke SpenceAug 28, 2025
Why is my Salamander Pumps CT leaking?
- V
  Vanessa AndersonAug 28, 2025
  If your Salamander Pumps Water Pump is leaking, consider these potential causes: * Pump exposed to mains water pressure: Fit a break cistern or remove the pump from the mains supply. * Pump suffered chemical damage: Ensure the pump hasn't come into contact with chemical substances like solder flux. * Pump exposed to excessive temperature: Check if effective temperature control is fitted (cylinder thermostat or HWS/TMV valve). * Unsure if the pump is leaking: Verify the leak isn't coming from a fitting in the pipework above the pump.
M
Megan LutzNov 9, 2025
What to do if Salamander Pumps CT Water Pump has reduced or intermittent flow?
- C
  Christopher HernandezNov 9, 2025
  If your Salamander Pumps Water Pump experiences reduced or intermittent flow, consider the following: * Incorrect or missing anti-aeration flange: Fit the appropriate anti-aeration flange. * Insufficient gravity flow: Refer to the instructions for checking gravity flow. * Blocked inlet filters: Ensure all filters and the shower head are free from debris. * Couplers restricting flow: Make sure all AV couplers are straight and not bent or distorted. * Air in the system: Run the system on full hot with the pump switched off (gravity only) for several minutes. Check the cold water storage and refill rate, and ensure vents are fitted as instructed. * Wrong size pump: Verify the pump's capacity is sufficient for the equipment. * Hot temperature set too high: Reduce the cylinder th...