EasyManua.ls Logo

Salamander Pumps RP55PS - User Manual

Salamander Pumps RP55PS
29 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
PERF
Salamander Pumped Shower Systems Limited
Unit 2c Colima Avenue, Sunderland, SR5 3XE
Tel: 0191 516 2002
Fax: 0191 548 4445
Email: service@salamanderpumps.co.uk

Table of Contents

Questions and Answers

  • B
    Briana StoneAug 9, 2025
    What to do if my Salamander Pumps RP55PS will not start?
    • K
      Kenneth StewartAug 9, 2025
      If your Salamander Pumps Water Pump isn't starting, there are several potential causes to investigate: * **Electrical Issues:** Verify the power supply, check the fuse, and inspect the circuit breaker. * **Incorrect Connections:** Ensure the inlet and outlet connections are plumbed correctly and that all valves are open. * **Insufficient Gravity Flow:** Confirm the installation complies with Salamander instructions, check the pump's suitability for negative head installations, ensure inlet filters are not blocked, and verify a minimum flow rate of 2l/min on both hot and cold water. * **Float Sticking:** Make sure there is no debris obstructing the outlet area. * **Flow switch malfunction:** Contact PumpWise on 0191 5162002.
  • L
    Lori DavidsonAug 23, 2025
    Why won't my Salamander Pumps RP55PS Water Pump start - Right Universal pumps additional checks?
    • J
      Johnathan TaylorAug 23, 2025
      If your Salamander Pumps Water Pump (Right Universal model) isn't starting, consider these additional checks: * **L.E.D. warning light lit:** See below conditions. * **L.E.D. 1 lit (pump hunting):** Check that all outlets are fully closed and there are no leaks on outlet pipe work. If fitted to toilets ensure ball valve in cistern is not passing water. Ensure equilibrium ball valve fitted. * **L.E.D. 2 lit (aeration – starvation of water):** Check cold water storage is correct for installation and pump is fitted to Salamander instructions. Flange fitted. Check pump filters are clear of debris. * **L.E.D. 3 lit (temperature):** Is effective temp control fitted (cylinder stat or HWS/TMV valve)?

Salamander Pumps RP55PS Specifications

General IconGeneral
ModelRP55PS
Voltage230V
Frequency50Hz
PhaseSingle
Heads2
Maximum Head Height15 meters
Shaft Seal MaterialCarbon/Ceramic

Related product manuals