Salto XS4 - User Manual

USER MANUAL
XS4 CODE LOCKER
The XS4 Code Locker provides a convenient security solution for
many different lockers, cabinets, boxes etc. Achieve simple access
through the keypad, without the need for a network connection.
Codes can be assigned and can be active for a specied time
period. It is easy to install and can be programmed via your mobile
phone.
The battery pack, electronic components and the locking
mechanism are all located on the inside off the door to prevent
vandalism and sabotage.
www.saltosystems.com
Publications of SALTO SYSTEMS S.L. are protected by copyright and all rights are reserved.
SALTO SYSTEMS publications may not be reproduced in any form or by any means without written permission from the copyright owner
XS4 CODE LOCKER LK50

Summary

Installation

Access Methods

Fixed User PIN Codes

Using pre-assigned PIN codes for locker access.

Free Assignment PIN Codes

Using any PIN code to capture and open/release the locker.

Timed PIN Codes

Using time-limited, autogenerated PIN codes for access.

Configuring Timed PIN Codes

Manual and WebApp configuration for timed PIN codes.

Fixed User PIN Codes Management

Add Fixed PIN Codes

Step-by-step guide to adding new fixed PIN codes.

Delete User Codes

How to remove existing fixed PIN codes from the device.

Device Configuration

Factory Reset

Restoring the device to its original factory settings.

Clear All Users

Removing all stored user PIN codes from the device.

Change User Configuration Code

Modifying the code used to access user settings.

Change Service Configuration Code

Modifying the code used to access service settings.

Special Functions

Enabling/disabling silent mode, high security, and free assignment.

Time and Date Configuration

Setting the current time and date for the locker.

Seed Code

Setting an 8-digit code for generating timed PIN codes online.

Enable Web App Configuration

Using VLC for device configuration via the WebApp.

Battery Monitoring

Battery Replacement

Information regarding battery replacement procedures.

Hardware Factory Reset

Technical Specifications

Salto XS4 Specifications

General

Technology	RFID
RFID Technologies Supported	iCLASS, DESFire, MIFARE
Power Supply	12-24V DC
Frequency	13.56 MHz
Operating Voltage	12-24V DC
Current Consumption	100 mA