Salus RT300RF User Manual

RT300RF INSTRUCTION MANUAL
9
CONTROL CENTRE JUMPER SETTINGS
Changes to the jumper settings should only be made by the Engineer
carrying out the installation or other qualified person.
The installer should select the jumper
positions required if changes need to be
made to the factory default settings. These
jumpers are found on the rear of the
Control Centre.
Jumper Function
Span Movable jumper for selecting temperature span
of ± 0.5°C (factory default setting) or ± 1.0°C
1,2,3,4,5 Removable jumpers for altering the RF address
code when used in conjunction with the
corresponding DIP switch on the Receiver.
NOTE:
The Reset button must be pressed after changing jumper positions.
The Reset button is accessible behind the small hinged door on the front
right hand side of the Control Centre.
Salus RT300RF Manual 002_89 22/07/2013 09:19 Page 9

Salus RT300RF Specifications

General

Frequency	868 MHz
Power Supply	2 x AA batteries
Display	LCD
Control Mode	On/Off
Programmable	Yes
Frost Protection	Yes
Type	Wireless
Mounting	Wall-mounted
Communication	Wireless
Range	30m
Compatibility	Boilers
Weight	150g
Temperature Range	5°C to 35°C