RT300RF INSTRUCTION MANUAL
5
INSTALLATION
Please read the important safety information at the start of this manual
before you begin to install the device.
The RT300RF Control Centre is easily installed using the Industry Standard
back plate supplied with the unit – this is used purely for mounting
purposes, as no wiring is needed for the Control Centre. The back plate can
be mounted directly to the wall surface.
The ideal position to locate the RT300RF Control Centre is about 1.5m above
floor level. It should be mounted in a location where the thermostat is
accessible, reasonably lit and free from extremes of temperature and
draughts. Do not mount the thermostat on an outside wall, above a radiator
or in a location where it may be subjected to direct sunlight.
To ensure trouble free operation of the Radio Frequency (RF) signal, always
ensure that the programmable thermostat is mounted away from any
possible sources of interference (such as radios, TV sets, computers, etc.),
and is not mounted on or in close proximity to large metal objects. Installing
the RT300RF in enclosed areas such as cellars and basements is not
recommended.
CONNECTING THE RT300RF RECEIVER
NOTE: All electrical installation work should be carried out by a suitably
qualified Electrician or other competent person.
If you are not sure how to install this digital thermostat consult either with
a qualified electrician, heating engineer or your boiler / heating system
supplier for advice on how to continue.
Salus RT300RF Manual 002_89 22/07/2013 09:19 Page 5
To Next Page
Loading...
Need help?
General
