RT300RF INSTRUCTION MANUAL
16
OPERATION
The RT300RF is configured and adjusted by
the use of a minimal number of user
controls, and an intuitive user interface.
The backlit Liquid Crystal Display (LCD)
gives a highly visible, easily readable
indication of the programmable thermostat
status.
REVIEWING SET POINT TEMPERATURE
You can view the set point temperature at any time by
pressing either the UP or DOWN key.
To exit from the set point review, press the BACKLIGHT /
FROST key, or don’t press any keys for approximately four
seconds – either of these actions will return the RT300RF
to displaying current room temperature.
SETTING SET POINT TEMPERATURE
You can change the set point temperature very easily
while you are reviewing the set point temperature. Press
the UP or DOWN keys repeatedly to change the
temperature setting. The set point temperature will flash
to indicate that it can be changed:
The temperature will be changed in 0.5°C steps per key press. The RT300RF
will return to Normal mode if no keys are pressed for more than four
seconds.
Set point temperature cannot be changed if Frost Protection mode is
enabled.
Salus RT300RF Manual 002_89 22/07/2013 09:19 Page 16
To Next Page
Loading...
Need help?
General
