RF ID CODE SETTING
Normally, the RT500 can link with the Boiler Control the ID code setting. If
there is another unit being used nearby, e.g. in the next house, your Boiler
Control may be triggered by the other RT500. You can change the RF ID
Code to help prevent this problem.
Each Boiler Control can only respond to RF transmissions from a RT500
with the same RF ID code setting.
To adjust the RF ID code of the RT500,
remove one or more of the jumper
caps located on the back of the unit
(labelled 1 to 5 as shown in this
picture): Then follow the steps below
to resync the RF communication.
RT500BC INSTRUCTION MANUAL
9
Salus RT500BC Boiler Control 026_89 21/01/2012 18:18 Page 9
To Next Page
Loading...
Need help?
General
