Salus RT510 - Frost protection mode

15
TEST / PAIRING
SELECT
SET
TEST / PAIRING
SELECT
SET
6.5 Frost protection mode
In this mode the setpoint temperature is automatically set to frost setpoint to prevent pipes from frosting. If the room temperature is lower than the frost
setpoint, frost protection will be enabled. To set frost protection mode follow steps below:
Press
TEST / PAIRING
SELECT
SET
button to turn
ON/OFF frost protection.
Snowake icon will be displayed if
frost protection is active.
The Frostpoint temperature can be reviewed by pressing the UP button once, but can only be changed in Installer Mode.
1 2