3 Installation and Operation
SAM4S SAP-630 SERIES 3-31
3-7 Installation
3-7-2 Installation of MSR Assembly
Caution :
ꞏ Before installation, be sure to turn off the power switch.
ꞏ Use gloves to protect your hand from being cut by the angle and the chassis.
ꞏ Connect all the cables correctly. When connecting or disconnecting the cables, be careful not to apply
stress to the cables. (It may cause disconnection)
ꞏ Be careful not to bind interface cables and AC power cord together.
1. Cut off the area (MSR assembly area) shown in the Figure 3-3-○
1
by using a (-) shaped screw driver.
2. Figure 3-3-○
2
shows the difference before and after.
Figure 3-3 MSR Installation (1)
To Next Page
Loading...
