SaMASZ KDF 390 User Manual

Operator’s manual
Front disc mower
KDF 390
- 6 -
4. SAFETY ADVICE AND WARNING
4.1. Safety rules and regulations
 During operation of the mower the Regulation of the Farm Ministry and Food Economy) from
12-01-1998 dealing with safety and hygiene during the operation of tractors, machinery, tools
and equipment used for farming (Dz. U. Nr 12/98 poz. 51), should be observed.
 Rear axis of the vehicle should be well weighted to keep the balance. If need be, use rear wheel
weights.
 The mower cannot be used if the vehicle has not been properly balanced.
 When mounting the mower on the vehicle be aware of the risk of wounding. The operator
should wear protective gloves.
 Operation without safety guards as well as with the damaged or raised guards is not allowed
(danger of the stones, etc. being thrown out). Damaged or worn safety guards should be replace
for new.
 During operation of farm machinery it is forbidden to open or remove any protective guards or
safety curtains.
 Condition of guards and its mounting should be checked regularly.
 DO NOT exceed 1050 PTO rpm.
 Nobody is allowed to remain within the danger area of at least 50 m. Particular caution is
necessary when operating near roads and in stoney areas.
 Any maintenance and adjustment work should only be done after the drive has been
disconnected and when the cutting discs have come to a complete standstill.
 Always check mower before starting work, in particular for damaged, missing and/or worn
knives and knife holders. Damaged or worn parts must be replaced.
 When the mower is lifted for repair on the 3-point linkage, it should be secured against falling
by a mechanical support or by chain.
 Any maintenance and adjustment work is allowed only with the mower lowered on the ground
or secured against falling by a mechanical support or by chain.
 Prior to performing any maintenance works, assembly, disassembly and break at work set the
machine onto a stable ground and protect against unintentional shifting.
 During cleaning machine, it should be used personal protection.
 The bolts and other fasteners have to be periodically checked and, if necessary, tightened or
replaced. DO NOT work with damaged or worn fasteners.
WARNING!
All service and repair operations must be done only after the
FORTSCHRITT’s engine has been stopped, all rotating parts have come to
the complete standstill and the cutterbar is on the ground.
WARNING! Working parts such as cutting knives and discs still rotate,
up to several seconds, before the rotor comes into complete standstill!
 No person nor object is allowed to be present on the mower or self-propelled machine
FORTSCHRITT when transported or operating.
 The operator is not allowed to leave the vehicle while driving.
 The mower shall never be started when it is lifted.
 The mower shall never be started, with people or animals near the machine.

SaMASZ KDF 390 Specifications

General

Brand	SaMASZ
Model	KDF 390
Category	Lawn Mower
Language	English