objects in the grass (stones, branches, piles of soil). In order to avoid clogging and jams, operating
speed should be adjusted to the mentioned conditions.
WARNING!
Removing clogs and jams while the machine is in operation can lead to the
accident!
In case of machine blockage caused by wrapped material, set the machine on a flat surface, remove
excess material using sharp tool. After clearing the machine check if nothing has been damaged.
To remove any clogging it is obligatory to disconnect the drive and the motor, take out the ignition
key. When eliminating any clogging on the machine, use also safety means for operator, so protective
gloves and tight wear.
5.7.5. Driving with mower over windrows when taking turns
Lift mower up by means of hydraulic cylinder and take a turn. Height of lifted up mower is enough
to have a drive over windrows without need of applying any lifting of mower on tractor lifting devices.
This is necessary, as not taking such maneuver may cause the cutter bar to get clogged with grass.
5.8. Unhitching the mower from tractor
WARNING!
When unhitching, make sure there is no person in between the mower and the
tractor.
To unhitch the mower from the tractor:
❑ left the swath,
❑ turn the driveline off, ignition and remove the ignition key,
❑ place the mower on an even, paved ground, then lower and inspect, if the mower is properly secured
against falling,
❑ secure the tractor against rolling down,
❑ lower and secure the support leg,
❑ dismount the PTO shaft and place it on a PTO shaft holder, that is standard-delivered with the
mower, PTO shaft and power input ends should be protected with guards.
❑ disconnect hydraulic hose,
❑ detach tractor's upper link and lower strands from mower's linkage,
❑ disengage the machine from hangers of the tractor's lower links by lifting the three-point linkage,
❑ carefully drive the tractor away.
To Next Page
Loading...
Need help?
General
