SaMASZ Spin - 10.3. Ordering Replacement Parts; 11. Storage; 12. Malfunctions and Their Repair

Operator’s manual
Bale wrapper
Spin
- 21 -
10.3. Ordering replacement parts
Spare parts should be ordered from resellers or directly form the manufacturer stating the
name and surname of the user or company name and address, name, symbol, serial number and year
of manufacture of the machine, catalogue name of the part, catalogue number, number of drawing
or standard, number of ordered items and agreed terms of payment.
11. STORAGE
The wrap counter should be stored in a dry place with the electrical connections protected
against fouling and humidity.
Store the wrapping machine on stands placed on hard, flat, level ground.
After the working season is over, clean the wrapping machine and check the condition of the
protective paint coating. Touch up the damage to the paint coating at a service workshop. Check the
condition and legibility of the nameplate. If the plate is damaged, notify the service station. Check
the condition and legibility of the symbols. If they are damaged, replace them with new ones.
It is advised to store the wrapping machine in a dry location, protecting it against UV rays and other
harmful agents.
12. MALFUNCTIONS AND THEIR REPAIR
No. Defect Reason Repair
1.
The wrapping machine works too
slowly.
Not enough oil in the
tractor’s hydraulic system.
Check the oil level in
the tractor. Top up oil.
2.
Oil leaks. Worn seal rings. Replace seal rings.
3.
The rotary frame does not rotate.
Broken or slack chain.
Replace or tighten the
chain.
Hydraulic motor damaged.
Check the engine
condition. Contact the
service agent.
4.
The bale does not revolve around
its axis.
Broken or slack drum
chains.
Replace or tighten the
drive chain.
13. DISASSEMBLY AND WITHDRAWAL FROM USE
If the wrapping machine cannot be repaired anymore, it should be withdrawn from use .
To do so, oil from the wrapping machine components should be drained and delivered to a proper
waste treatment company. Clean the wrapping machine parts, dismantle and dispose properly of all
plastic parts. After that, the wrapping machine can be scrapped.