Operator’s manual
Bale wrapper
Spin
- 6 -
DO NOT operate the wrapping machine unless all safety guards are in place and operational. In
addition, any damaged protective aprons should be replaced with new ones
No person (except operator) should stand within danger area which is a minimum of 164' 1"
from any operating part, especially when operating near roads and in areas with stones and other
debris.
Be certain that children and animals are at a safe distance away from the machine
.
IMPORTANT: Maintenance and adjustment should ONLY be done after the following has
occurred:
tractor’s engine has been stopped
and ignition key has been taken out,
all rotating parts have come to complete standstill,
Never tamper with or remove safety devices on the machine or make them inoperable.
Before starting work and periodically thereafter, replace any damaged, missing and/or worn
parts.
When driving on public roads always comply with local traffic regulations, especially those
concerning warning lights.
When the wrapping machine is lifted for repair, it should be secured against falling by
mechanical support or by chain.
The bolts and other fasteners have to be periodically checked and, if necessary, tightened or
replaced. DO NOT work with damaged or worn fasteners.
Never lift the wrapping machine on tractor linkage when the drive is operating and the cutting
discs are rotating.
When operating the wrapping machine, the tractor should always be equipped with operator
protection that is required by laws and regulations.
Before you start the tractor make sure that all drives are turned off and the levers that turn the
hydraulics are in neutral position.
Never leave tractor’s engine running without supervision. Before you leave the tractor, turn off
the engine and remove the key from tractor’s ignition.
DO NOT operate the wrapping machine when driving the tractor backwards.
Permissible inclination of the wrapping machine on a slope when working and during transport
is 8°. Exceeding this incline can result in machine tipover.
Never stand between tractor and wrapping machine unless tractor and wrapping machine are
secured against moving by the tractor’s brake.
If any maintenance must be done under an elevated wrapping machine, it must be blocked or
otherwise secured against falling.
The wrapping machine should be stored under a roof and in a way as to not be hazardous bot
people or animals.
In the event of an accident involving this wrapping machine in a field or on a road, follow all
applicable first aid procedures and contact SaMASZ technical service.
Wrapping machine should be kept clean, so as to avoid danger of fire.
4.2. Hazards
Description of residua risks
Despite the fact that SaMASZ Białystok, the manufacturer of the wrapping machine, has
taken great care in the design and manufacturing of the wrapping machine, certain risks during
wrapping machine operation and maintenance are unavoidable. A major source of risk that could
result in serious injury or death can occur during the performance of these operations.
Major source of risk follows performance of these operations:
installation of the wrapping machine on tractors which do not meet the required minimum
criteria stated in this manual,
To Next Page
Loading...
