Samson 2405 - Measures for Preparation; Unpacking; Transporting and Lifting

EB 2520 EN 19
Measures for preparation
4 Measures for preparation
After receiving the shipment, proceed as fol-
lows:
1. Checkthescopeofdelivery.Compare
the shipment received with the delivery
note.
2. Checktheshipmentfortransportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.1 Unpacking
Do not remove the packaging until immedi-
ately before installing the valve into the pipe-
line.
Proceed as follows to lift and install the de-
vice:
1. Remove the packaging from the device.
2. Dispose of the packaging in accordance
with the valid regulations.
4.2 Transporting and lifting
Due to the low service weight, lifting equip-
ment is not required to lift and transport the
device (e.g. to install it into the pipeline).
Risk of valve damage due to incorrectly at-
tached lifting equipment.
Do not attach lifting equipment to mounting
parts (e.g. adjusting screw or control line).
Transport instructions
− Protectthedeviceagainstexternalinu-
ences (e.g. impact).
− Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
− Protect the device against moisture and
dirt.
− Observe the permissible ambient tem-
peratures(seesection3.1).
NOTICE
!