Samson 2405 - Storage; Preparation for Installation

20 EB 2520 EN
Measures for preparation
4.3 Storage
Risk of regulator damage due to improper
storage.
− Observe the storage instructions.
− Avoid long storage times.
Contact SAMSON in case of different stor-
age conditions or longer storage times.
We recommend to regularly check the device
and the prevailing storage conditions during
long storage periods.
Storage instructions
− Protectthedeviceagainstexternalinu-
ences (e.g. impact).
− Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
− Protect the device against moisture and
dirt. Store it at a relative humidity of less
than75%.Indampspaces,preventcon-
densation. If necessary, use a drying
agent or heating.
− Make sure that the ambient air is free of
acids or other corrosive media.
− Observe the permissible ambient tem-
peratures(seesection3.1).
− Do not place any objects on the device.
NOTICE
!
Note
4.4 Preparation for installation
Î Flush the pipelines.
The plant operator is responsible for clean-
ing the pipelines in the plant.
Î Ensure that there is no liquid, e.g. con-
densed water, inside the regulator. If nec-
essary, blow out the connecting parts
with clean compressed air.
Î Checkthevalvetomakesurethatitis
clean.
Î Checkthevalvefordamage.
Î Checktomakesurethatthetypedesig-
nation, valve size, material, pressure rat-
ing and temperature range of the valve
match the plant conditions (size and
pressure rating of the pipeline, medium
temperature etc.).
Note