Samson 2405 - Page 9

EB 2520 EN 9
Safety instructions and measures
NOTICE
!
Risk of regulator damage due to incorrectly attached slings.
Î Do not attach load-bearing slings to the actuator housing.
Risk of valve damage due to unsuitable medium properties.
Thevalveisdesignedforaprocessmediumwithdenedproperties.
Î Onlyusetheprocessmediumspeciedforsizingtheequipment.
Risk of leakage and valve damage due to excessively high or low tightening
torques.
Observethespeciedtorqueswhentighteningvalvecomponents.
Excessive tightening torques lead to parts wearing out more quickly. Parts that are too
loose may cause leakage.
Î Observethespeciedtighteningtorques.
Risk of regulator damage due to the use of unsuitable lubricants.
The lubricants to be used depend on the regulator material. Unsuitable lubricants may
corrode and damage surfaces.
Î Only use lubricants approved by SAMSON.
When in doubt, consult SAMSON.
Risk of regulator damage due to the use of unsuitable tools.
Certaintoolsarerequiredtoworkontheregulator.
Î Only use tools approved by SAMSON.
When in doubt, consult SAMSON.
Risk of excess pressure damaging plant sections due to construction-related seat
leakage through the regulator.
Î Always install a safety device (e.g. safety excess pressure valve or safety relief
valve) in the plant.
SAMSON's After-sales Service can support you concerning lubricant, tightening torques
and tools approved by SAMSON.
Note