Samson 2413 Series User Manual

10 EB 2517 EN
Safety instructions and measures
1.3 Notes on possible property damage
NOTICE
!
Risk of regulator damage due to incorrectly attached slings.
Î Do not attach load-bearing slings to the actuator housing.
Risk of regulator damage due to unsuitable medium properties.
Theregulatorisdesignedforaprocessmediumwithdenedproperties.
Î Onlyusetheprocessmediumspeciedforsizing.
Risk of regulator damage due to contamination (e.g. solid particles) in the pipeline.
The plant operator is responsible for cleaning the pipelines in the plant.
Î Flush the pipelines before start-up.
Î Observethemaximumpermissiblepressureforregulatorandplant.
Risk of regulator damage due to the use of unsuitable lubricants.
The lubricants to be used depend on the regulator material. Unsuitable lubricants may
corrode and damage the surface.
Î Only use lubricants approved by SAMSON. When in doubt, consult SAMSON.
Risk of leakage and regulator damage due to excessively high or low tightening
torques.
Observethespeciedtorquesontighteningregulatorcomponents.Excessivelytightened
torques lead to parts wearing out quicker. Parts that are too loose may cause leakage.
Î Observethespeciedtighteningtorques.
Risk of regulator damage due to the use of unsuitable tools.
Certain tools are required to work on the regulator.
Î Only use tools approved by SAMSON.
SAMSON's After-sales Service department can support you concerning lubricant, tight-
ening torques and tools approved by SAMSON.
Note

Samson 2413 Series Specifications

General

Brand	Samson
Model	2413 Series
Category	Control Unit
Language	English