EasyManuals Logo

Samson 2413 Series User Manual

Samson 2413 Series
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
EB 2517 EN 45
Malfunctions
Table9: Troubleshooting
Malfunction Possible reasons Recommended action
Upstream pressure
exceedstheadjusted
set point.
Insufcientpressurepulsesonthe
operating diaphragm.
Î Connect the control line on site for regulators
withexternalcontrolline.
Î Cleanthecontrollineandscrewttings.
Pressure tapped at the wrong place
(regulatorwithexternalcontrolline).
Î Reconnect the control line at another point.
Î Do not connect the control line at pipe bends or
necks.
Regulatorinstalledagainsttheow.
Î Installtheregulatorsothatthedirectionofow
matches the direction indicated by the arrow on
the body.
Regulator or K
VS
/C
V
coefcienttoo
small
Î Checkthesizing.
Î Change K
VS
/C
V
coefcient,ifnecessaryorin-
stalladifferentsizedregulator.
Î Contact SAMSON's After-sales Service depart-
ment.
Foreign particles blocking the plug
Î Remove foreign particles.
Î Replace damaged parts.
Î Contact SAMSON's After-sales Service depart-
ment.
Compensation chamber in the wrong
position or too small (with steam).
Î Reconnect compensation chamber at a different
placeorreplaceit(seesection7.7).
Defective operating diaphragm Î Replace damaged diaphragm.
Pressure drops below
the adjusted set point.
Foreign particles blocking the plug
Î Remove foreign particles.
Î Replace damaged parts.
Î Contact SAMSON's After-sales Service depart-
ment.
Seat and plug are worn or leak.
Î Replace the damaged seat and plug.
Î Contact SAMSON's After-sales Service depart-
ment.
Pressure tapped at the wrong place
(regulatorwithexternalcontrolline).
Î Reconnect the control line at another point.
Î Do not connect the control line at pipe bends or
necks.
Regulator or K
VS
/C
V
coefcienttoo
large
Î Checkthesizing.
Î Change K
VS
/C
V
coefcient,ifnecessaryor
installadifferentsizedregulator.
Î Contact SAMSON's After-sales Service depart-
ment.
Control line blocked Î Cleanthecontrollineandscrewttings.
Strainer blocked. Î Clean strainer.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Samson 2413 Series and is the answer not in the manual?

Samson 2413 Series Specifications

General IconGeneral
BrandSamson
Model2413 Series
CategoryControl Unit
LanguageEnglish

Related product manuals