What to do if Samson Control Unit flow set point not reached?
If the flow set point is not reached on your Samson Control Unit, a blocked control line could be the reason. Make sure to clean the control line and screw fittings. Alternatively, the strainer might be blocked, so clean the strainer.
Why is there a jerky control response on Samson Control Unit?
If your Samson Control Unit exhibits a jerky control response, it could be due to increased friction, potentially caused by foreign particles between the seat and plug. Remove any foreign particles and replace damaged parts to address this issue.
Why Samson Control Unit makes loud noises?
If your Samson Control Unit is producing loud noises, it might be due to high flow velocity or cavitation. Check the sizing and install a larger regulator if necessary.
What to do if my Samson Controller has an input signal failure?
If your Samson Controller experiences an input signal failure, especially when c31 = YES, the suggested solution is to check the signal source and wiring.
What to do if my Samson Controller is blocked?
If your Samson Controller experiences a blockage, especially when c51 = YES, you should check the attachment and valve, if necessary. Also check the actuator stem.
What to do if flow set point not reached on Samson Control Unit?
General| Brand | Samson |
|---|---|
| Model | 3214 |
| Category | Controller |
| Language | English |
To Next Page
