Samson D3500 - Using Two D3500 s for Mains and Monitors

21
System Configurations
Using Two D3500’s for Mains and Monitors
In this example, two D3500’s are used for the stereo main and for the 2-channel monitor mix. The mixer’s left and right outputs are connected to the first D3500’s inputs for the main
PA speakers. Then, the outputs are connected to the inputs of the power amplifier connected to passive loudspeakers. For the monitor mix, the mixer’s AUX1 output is connected to the
second D3500’s channel 1 input and AUX2 output is connected to the channel 2 input. Then, the second D3500’s channel outputs are connected to the inputs of the 2-channel power
amp. Finally, the power amplifiers outputs are connected to the passive (non-powered) monitor loudspeakers.
D3500_ownman_v1_2.indd 21 9/4/05 5:21:19 PM