Quick Set-Up
In the following pages of this manual, you will find a detailed explanation of all the dB300a’s functions
and controls, but if you just want to get started quickly you can follow the steps below.
Using a Microphone
• Be sure that the dB300a’s Power switch is set to
the off position.
• Turn the LINE and MIC LEVEL controls fully coun
-
terclockwise to the off position.
• Connect the power cable to an AC socket.
• Using a standard XLR cable, plug a microphone
into the dB300a’s MIC INPUT.
• Switch the dB300a’s Power switch to the ON posi
-
tion.
• While speaking into the microphone, slowly raise
the MIC LEVEL control until you have reached the
desired level.
Using a Line Level Signal
• Be sure that the dB300a’s Power switch is set to
the off position.
• Turn the LINE and MIC LEVEL controls fully coun
-
terclockwise to the off position.
• Connect the power cable to an AC socket.
• Using a standard XLR or 1/4 inch cable, connect
a line level signal from a mixer or keyboard into
the dB300a’s LINE INPUT.
• Switch the dB300a’s Power switch to the ON
position.
• Now, run an audio signal from your mixer (like
some music from a CD) while slowly raising
the dB300a’s LINE LEVEL control until you have
reached the desired level.
IMPORTANT NOTE: Be sure to keep the MIC LEVEL control all the way off if there is no microphone connected.
ENGLISH
6
To Next Page
Loading...
