Setting Up Your dB300a System
Using Speaker Stands
The dB300a enclosure features a standard 1 3/8”,
pole mount receptacle, which is compatible with
speaker stands from a variety of manufacturers.
Before installing the dB300a on a speaker stand,
loosen the thumbscrew located on the bottom of
the rear side of the enclosure. Once installed on
the stand, be sure to tighten the thumbscrew to
hold the speaker in place. Be careful not to over
tighten the thumbscrew to avoid stripping the
threads.
Stacking the dB300a
The dB300a enclosure incorporates gender mating
stack feet and bumpers that allows you to stack
one dB300a on top of another. When stacking
the dB300a’s, be certain that the rubber feet from
the top unit are securely fastened into the bottom
unit’s stacking bumpers.
NOTE: DO NOT STACK dB300a’s OVER TWO (2)
TALL.
ENGLISH
10
To Next Page
Loading...
