18
11. When first setting up the XP40iw System in a new environment, it’s always a
good idea to do a walk-around in order to make sure that coverage is provided for
your entire performance area. As you do so, the “RF” LED on the rear panel of the
XP40iw should always remain lit. Always try to minimize the distance between
transmitter and receiver as much as possible so that the strongest possible signal is
received from all planned transmission points.
If you have followed all the steps above and are experiencing difficulties, contact your
local distributor or, if purchased in the United States, call Samson Technical Support
(1-800-372-6766) between 9 AM and 5 PM EST.
Using the XP40iw Wireless Microphone
To Next Page
Loading...
