To Next Page
S
Scott OconnorSep 12, 2025
How to initialize Samson Valve Positioners?
- JJustin KellySep 12, 2025
To address a positioner that is not initialized, set the parameters and initialize the Samson Valve Positioner using Code P22.
How to initialize Samson Valve Positioners?
To address a positioner that is not initialized, set the parameters and initialize the Samson Valve Positioner using Code P22.
What to do if there is no reading on the display of Samson Valve Positioners?
If there is no reading on the display of your Samson Valve Positioner, check the electrical connection and power supply.
General| Type | Electropneumatic positioner |
|---|---|
| Input signal | 4 to 20 mA |
| Output signal | Pneumatic |
| Protection class | IP 66 |
| Communication | HART |
| Signal range | 4 to 20 mA |
| Ambient temperature range | -40 to +80 °C (-40 to +176 °F) |
| Enclosure rating | IP 66 |
| Housing material | Aluminum |
