Samson TROVIS 5573 - 4 Shipment and on-site transport; 4.1 Accepting the delivered goods; 4.2 Removing the packaging from the controller; 4.3 Transporting the heating controller

EB 5573 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this chapter is only to
be performed by personnel appropriately
qualiedtocarryoutsuchtasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Compare the shipment received with the
delivery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.2 Removing the packaging
from the controller
Do not remove the packaging until immedi-
ately before mounting and start-up.
1. Remove the packaging from the control-
ler.
2. Checkscopeofdelivery(seeFig.4-1).
3. Dispose and recycle the packaging in ac-
cordance with the local regulations.
Note
1x TROVIS5573 Heating and District
Heating Controller
1x DocumentIP5573(ImportantProduct
Information)
Fig.4-1: Scope of delivery
4.3 Transporting the heating
controller
Transport instructions
− Protect the controller against external in-
uences(e.g.impact).
− Protect the controller against moisture
and dirt.
− Observe transport temperature depend-
ing on the permissible ambient tempera-
ture (see the 'Design and principle of op-
eration' chapter).
4.4 Storing the controller
Risk of controller damage due to improper
storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions.
We recommend to regularly check the con-
troller and the prevailing storage conditions
during long storage periods.
NOTICE
!
Note