Samson TROVIS 5573 - Page 47

EB 5573 EN 8-5
Setup
8.2.3 Setting the party timer (special time-of-use)
Using the Party mode function, the controller continues or activates the rated operation of the
controller during the time when the party timer is active, regardless of the programmed
times-of-use. After the party timer has counted down, the party time function is reset to
00:00
Parameter Default Value range
Continue or activate rated
operation
0h 0to48h
How to proceed:
1. Turn the rotary switch to
(party mode).
blinks.
InthesystemsAnl1.0,1.9and3.5,00:00ortheremainingtimeofthepartytimeare
displayed. The following steps 2 and 3 (to select the control circuit) are not required.
2. Select the control circuit in which day mode is to be activated or continued [q]:
1: Heating circuit 1
2: Heating circuit 2
3: DHW circuit
Only those control circuits are available for selection which can be controlled by the se-
lected system.
3. Conrmtheselectedcontrolcircuit[Û].
Reading: 00:00 or the remaining time of the party time
4. Extend day mode as required [q].
The time is set in steps of 15 minutes.
5. Turn the rotary switch back to normal switch position
(information level).
The party timer runs down in steps of 15 minutes.
8.2.4 Programming public holidays (special times-of-use)
Onpublicholidays,thetimes-of-usespeciedforSundayapply.Amaximumof20public
holidays may be entered.
Note