18 EB 8355-1 EN
Attachment to control valve
Table 5 Control valve Travel [mm] With lever Order no.
NAMUR mounting kit
Refer to Fig. 7
concerning parts
Valve with cast yoke 7.5 to 60 N1 (125 mm) 1400-6787
22.5 to 120 N2 (212 mm) 1400-6789
Valve with
rod-type yoke,
rod diameter
[mm]
20 to 25 N1 1400-6436
20 to 25 N2 1400-6437
25 to 30 N1 1400-6438
25 to 30 N2 1400-6439
30 to 35 N1 1400-6440
30 to 35 N2 1400-6441
Attachment to Fisher and Masoneilan linear actuators
(one each of both mounting kits is required per actuator)
1400-6771
and
1400-6787
Additional range spring acc. to Table 6 Range spring 1 (9.5 coils, installed as standard)
Range spring 2 (4.5 coils)
1400-6442
1400-6443
Accessories Order no.
Pressure gauge build-on block G ¼ 1400-7458
¼ NPT 1400-7459
Pressure gauge kit Stainless steel/Brass 1400-6950
Stainless steel/Stainless steel 1400-6951
Filter check valve, replaces the vent plug and increases the degree of protection to IP 65 1790-7408
Assortment of spare parts including seals and diaphragms 1400-9895
Table 6
Travel [mm]* 7.5 15 15 30 30 60 30 60 60 120
Pin on marking* 1212121212
Distance pin/fulcrum of the lever 42 to 84 mm 84 to 168 mm
With lever N1 (125 mm long) N2 (212 mm long)
Pin (27a) on position A A B A B
Range spring required (see Table 5) 21111
* Intermediate values must be interpolated
To Next Page
Loading...
