23
UT-4 Multi-pin Lavalier
Wiring Guide
The UT-4 transmitter can be used with a wide range of lavalier micro-
phones, headset microphones and instruments (such as electric guitar
or bass). The illustration below shows the wiring connections for its
multi-pin input connector:
Samson Technologies offers the following pre-wired input accessory
cables for the UT-4:
Part Number Description
————————————————————————————————
GC-1 Instrument cable, suitable for use with electric guitar or
bass, etc. Terminates at standard 1/4” phone plug.
MC-1 Low-impedance microphone cable, suitable for use with
most dynamic and condenser microphones.
Terminates at standard 3-pin XLR plug.
We offer the following lavalier microphones, available pre-wired for use
with the UT-4: Sony
ECM-44, ECM-55, ECM-77; Sennheiser MKE-2;
Audio Technica 831C.
We also offer the following headsets, available pre-wired for use with
the UT-4: AKG
C-410; Audio-Technica AT-71B; and Countryman
IsoMax.
For information about connecting other lavalier microphones and
headsets to the UT-4, refer to the chart on the following two pages.
To Next Page
Loading...
