Samson UHF series - UR-4 Rear Panel

7
Guided Tour - UR-4 Rear Panel
1: AC input - Connect the supplied standard 3-pin “EEC” plug here.
2: Balanced output* - Use this electronically balanced low impedance
(600 Ohm) XLR jack when connecting the UR-4 to professional (+4)
audio equipment. Pin wiring is as follows:
* If required, both the balanced and unbalanced outputs can be used
simultaneously.
1
2
3
44
DISTRIBUTOR A
SAMSON
SAMSON TECHNOLOGIES CORP.
HICKSVILLE, NEW YORK, U.S.A.
UHF RECEIVER MODEL No.UR-4
ANT - A
120V~60Hz 15W
POWER
RATING
!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
ATTENTION: RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR.
ATTENTION: ANTENNA CONNECTIONS ARE POWERED BY DC 9V
MANUFACTURED UTILIZING TECHNOLOGY, LICENSED FROM CARILLON TECHNOLOGY INC.
DBX IS A REGISTERED TRADEMARK OF CARILLON ELECTRONICS CORPORATION.
ANT - A
BALANCED OUTPUT
-60dBm.600Ω
UNBALANCED
OUTPUT
-10dBv.5KΩ
GND
HOT
COLD
1
2
3
FCC ID 8GPUR - 4
MADE IN JAPAN
3 - SIGNAL
2 + SIGNAL
1 GROUND
+