Samson UHF series - Page 27

25
UT-4 Multi-Pin Wiring Chart
Pin 3 Pin 4 Pin 5 Pin 6
———————————————————————————————————
N/C N/C N/C Red
N/C N/C N/C Red
15KΩ Resistor N/C N/C Shield
to pin 2
15KΩ Resistor N/C N/C Shield
to pin 2
15KΩ Resistor N/C N/C Shield
to pin 2
N/C N/C N/C Yellow (2x)
Shield
N/C N/C N/C Shield
N/C N/C N/C Shield
N/C N/C Jumper-to-pin 2 Shield
N/C N/C N/C Shield
Jumper-to-pin 2 N/C Jumper-to-pin 6 Shield
Jumper-to-pin 2 N/C Jumper-to-pin 6 Shield
N/C N/C N/C Blue & Shield
Jumper-to-pin 2 N/C Jumper-to-pin 6 Shield
N/C N/C N/C Black & Shield
Jumper-to-pin 2 N/C N/C Shield
Jumper-to-pin 2 N/C N/C Shield
Jumper-to-pin 2 N/C N/C Shield
N/C N/C N/C Shield
N/C Audio N/C Shield
N/C N/C XLR-2 XLR-1 & 3
(Audio) (GND)
N/C Audio N/C Shield
Ground Hi-Z Mic Ground
Bipolar Audio Lo-Z Unipolar
NOTES:
• Resistors in plugs should be SMD (Surface Mount Device) or miniature type.
• Users of Sennheiser MKE-40: Add a 100pF capacitor between pin 2 and pin 5 only if necessary.
For more information, call Samson Technical Support at 1-800-372-6766.