Samson XPD2 User Manual

6
HXD1 Controls
1. Status Indicator - This LED
displays the operation mode:
Amber: Normal Operation
Flashing Amber: Pairing / Low
Battery
2. Power/Pair Switch - Press less
than 5 seconds to turn the
unit on or off. Press more
than 5 seconds to enter pair-
ing mode.
3. Battery Cover - Unscrew the
battery cover and slide down
to open the HXD1 battery
compartment.
4. Battery Holder - Open the
battery holder by pressing
the tab and lifting the cover.
Insert two standard AA (LR6)
batteries here, being sure to
observe the plus and minus
polarity markings shown.
WARNING: Do not insert the
batteries backwards; doing so
can cause severe damage to
the HXD1 and will void your
warranty.
5. Input GAIN Control - This
control adjusts the transmitter
input sensitivity.
6. Screwdriver - Used to adjust
the input GAIN control.

Samson XPD2 Specifications

Operating Environment

operating temperature	10°C - 40°C
working range	100' line of sight
working frequency	2.404-2.476 GHz

Power

power requirements	two AA alkaline batteries
battery life	20 hours
operating voltage	5V DC

Audio Specifications

audio frequency response	20 Hz - 17 kHz
signal to noise ratio	>85 dB
audio sample rate	32 kHz

Weight and Dimensions

weight	0.21 lb / 93 g
dimensions (HxLxD)	96 mm x 62 mm x 18.5 mm
dimensions (LxDxH)	89 mm x 23 mm x 8 mm