English - 48
Setting the On/Off Timer
1.
Press the MENU button to display the menu.
ENTER
button.
ENTER button.
2.
button to select “Timer 1”, “Timer 2” or “Timer 3”, then press the ENTER
button.
3.
On Time: Set the Hour, Minute, am/pm, and Activate/Inactivate.
(To activate timer with the setting you’ve chosen, set to “Activate”.)
Off Time: Set the Hour, Minute, am/pm, and Activate/Inactivate.
(To activate timer with the setting you’ve chosen, set to “Activate”.)
Volume: Set the required volume level.
Contents
TV/USB: Select TV or USB. (Make sure that an USB device is
connected to your TV.)
Antenna: Select “Air” or “Cable”.
Channel: Select the desired channel.
Repeat: Select “Once”, “Everyday”, “Mon~Fri”, “Mon~Sat”, “Sat~Sun”,
or “Manual”.
desired day of the week. Press the ENTER
button over the
desired day and the mark will appear.
•
•
•
•
–
–
–
–
–
•
➣
Press the EXIT button to exit.
You can set the hour, minute and channel by pressing the number
buttons on the remote control.
Auto Power Off
When you set the timer On, the television will eventually turn off, if no
controls are operated for 3 hours after the TV was turned on by the
timer. This function is only available in timer On mode and prevents
overheating, which may occur if a TV is on for too long time.
➣
➣
Setup
Plug & Play
Language : English
V-Chip
Caption
External Settings
Entertainment : Off
Energy Saving : Off
PIP
SW Upgrade
Contents
TV
TV/USB
am
Channel
None
Music
ReturnEnter
Adjust
Move
Cable
Antenna
3
Channel
None
Photo
Time
Clock : 12 : 00 am
Sleep Timer : Off
Timer 1 : Inactivated
Timer 2 : Inactivated
Timer 3 : Inactivated
ReturnEnter
Move
Timer 1
12 00 am Inactivate
00 am Inactivate
On Time
Off Time
12
Once
ReturnEnter
Adjust
Move
Volume
10
Contents
Repeat
Sun Mon Tue Wed Thu Fri Sat
TV Cable 3
To Next Page
Loading...
