English - 60
Upgrading the Software
(726-7864) to receive information about downloading upgrades and using a USB drive. Upgrades will be possible by
connecting a USB drive to the USB port located on your TV.
1.
on the side of the TV.
2.
Press the MENU button to display the menu.
ENTER
button.
3. ENTER
button.
4.
Press the ENTER
button.
The message “Scanning for USB... It may take up to 30 seconds.” is
displayed.
5. The message “Upgrade version XXXX to version XXXX? The system will be
reset after upgrade.” is displayed.
ENTER
button.
Please be careful to not disconnect the power or remove the USB drive while
upgrades are being applied. The TV will turn off and turn on automatically
after the upgrades are complete. When software is upgraded, video and
audio settings you have made will return to their default (factory) settings. We
recommend you write down your settings so that you can easily reset them
after the upgrade.
Setup
Energy Saving : Off
PIP
Software Upgrade
Scanning for USB.....
It may take up to 30 seconds.
Software Upgrade
Upgrade version XXXX to version XXXX? The system will
be reset after upgrade.
OK
Cancel
To Next Page
Loading...
