6
Installation Procedure
English
Installation Procedure
CAUTION
• Depending on the condition of power supply, unstable
power or voltage may cause malfunction of the parts
or control system. (At the ship or places using power
supply from electric generator...etc)
• Install the unit in a place where water can drain smoothly.
• If you have any difficulty finding installation location as
prescribed above, contact your manufacturer for details.
• Be sure to clean the sea water and the dust on the
heat exchanger of the outdoor unit and apply a
corrosion inhibitor on it. (At least once in a year.)
• Check the condition of the product periodically.
– Check the installation site every 3 months and
perform anti-corrosion treatment such as R-Pro
supplied by SAMSUNG (Code: MOK-220SA) or
commercial water repellent grease and wax, etc.,
based on the product condition.
– When the product is to be shut down for a long
period of time, such as off-peak hours, take
appropriate measures like covering the product.
• If the product installed within 500m of seashore,
special anti-corrosion treatment is required.
࢜
Please contact your local SAMSUNG
representative for further details.
Outdoor unit dimensions
(Unit: mm)
Type A
AC052TXADKC
880
310
15
338
638
661
58
Type B
AC071TXADKC
880
49
798
310
661
338
15
Type C
AC100TXAD*C
940
977
998
528
537
675
330
360
384
620
Type D
AC120/140TXAD*C
1185
940
1210
558
567
675
330
620
360
384
Type E
AC160TXAD*C
940
1395
1420
558
567
1095
330
620
360
384
To Next Page
Loading...
Need help?
General
