How to troubleshoot indoor temperature sensor (open/short error) -Zone2 on Samsung Heating System?
If your Samsung Heating System displays an indoor temperature sensor (open/short error) for Zone2, check the indoor unit room temperature sensor and the indoor unit PCB connector CNS043 Terminal(B15/B16).
How to troubleshoot indoor temperature sensor (open/short error) -Zone1 on Samsung Heating System?
If your Samsung Heating System displays an indoor temperature sensor (open/short error) for Zone1, check the indoor unit room temperature sensor and the indoor unit PCB connector CNS043(White).
What to do if IPM is overheated in Samsung Heating System?
If the IPM is overheated in your Samsung Heating System, check the INVERTER PBA's temperature. Power off and cool down the INVERTER PBA, then restart the outdoor unit.
What to do if PFC Overload Error appears on Samsung Heating System?
If your Samsung Heating System is showing a PFC Overload Error, check the reactor located in the control plate. If the reactor is normal, replace the INVERTER PBA.
How to fix Inverter EEPROM loading error on Samsung Heating System?
If you encounter an inverter EEPROM loading error with your Samsung Heating System, check the EEPROM DATA and ensure the PCB is operating normally.
What to do if [Inverter] IPM over current error occurs in Samsung Heating System?
If you are encountering an IPM over current error on your Samsung Heating System, verify the coolant charging status. Also, check the compressor connection and ensure it's operating normally. Inspect for any obstructions around the indoor and outdoor units. Confirm that the outdoor unit service valve is open and that the indoor/outdoor installation pipe and wiring are correctly installed.
What should I check for indoor unit Eva In sensor (Open/Short) error in Samsung Heating System?
If your Samsung Heating System shows an indoor unit Eva In sensor (Open/Short) error, check the indoor unit Eva in sensor location.
How to troubleshoot compressor V limit error on Samsung Heating System?
If your Samsung Heating System displays a compressor V limit error, check the compressor connection status and the resistance between different phases of the compressor.
What to do when Samsung Heating System OUTDOOR UNIT is under protection due to overload?
If the outdoor unit of your Samsung Heating System is under protection due to overload, check the cycle status. Also, check the compressor when it starts.
What to do if Samsung Heating System detects OUTDOOR UNIT compressor freezing?
If your Samsung Heating System detects outdoor unit compressor freezing, check the cycle status, specifically if the outdoor unit (condenser) is frozen. Inspect the condenser.
Safety guidelines for service, static electricity, and general handling.
Protocols for safe management of refrigerants and brazing operations.
Overview of the EHS system's features and technical details.
Detailed technical specifications for outdoor and hydro units.
Specifications for optional accessories and items.
Lists necessary tools and disassembly steps for units.
Troubleshooting guide for wired remote controller error codes.
Troubleshooting common errors in hydro units like EEPROM, sensors, pump.
Diagnostic procedures based on system symptoms and error codes.
Diagrams identifying components on various PCBs.
Electrical wiring schematics for different unit configurations.
Guide to model naming and system component identification.
Procedures for checking, updating, importing, and exporting FSV data.
General| Cooling Capacity | 8.0 kW |
|---|---|
| Heating Capacity | 9.0 kW |
| Seasonal Energy Efficiency Ratio (SEER) | 6.1 |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Noise Level (Outdoor) | 52 dBA |
To Next Page
