ENGLISH-56
Electrical wiring work
Examples of how to use the cable striper
<Cable striper>
1. Adjust the blade position by coin. (Controller is at the bottom side of the tool.) Fix the blade
position according to the outer sheath thickness of the power cable.
2. Fix the power cable and tool by using the hook at the top side of the tool.
3. Cut out the outer sheath of the power cable by revolving the tool in the direction of the arrow,
two or three times.
4. At this situation, cut out the outer sheath of the power cable by moving the tool toward the
direction of the arrow.
5. Slightly bend the wire and pull out the cut part of the outer sheath.
Fixing the power cable
• Do not let the power cable come into contact with the pipes inside the outdoor unit. If the power supply cable
touches the pipes, the vibration of the compressor is transferred to the pipes and can damage the power supply
cables or pipes, creating the danger of re or explosion.
• Make sure that the place where the sheath of power supply cable is removed is inside the power supply box. If it
is impossible, you should connect the protection tube for power cable to the power supply box.
• After arranging the power cable into the power supply box, tighten the cover.
CAUTION
Connect the ring terminal of 3 phase cable
1. Cut the power cable to an appropriate length and connect it with the solderless terminal.
2. After connecting the power cable to the terminal as seen in the illustration, x it with cable tie.
3. Fix the housing, which has an insulator, to the terminal board.
To Next Page
Loading...
