Disassembly and Reassembly
Samsung Electronics 271
No Parts Procedure Remark
1 Control Part 1) Remove the 3 fixed screws to remove the
Control-Box Cover. (Use +Screw Driver)
2) Disconnect the Connector Wire that is con
-
nected to the indoor unit’s PBA.
3)
Unscrew the 2 fixed screws on both sides of
the Control Box, and disassemble the Control
Box from the indoor unit.
(Use +Screw Driver)
2 Drain Pan 1) Unscrew the screws on the 4 corners of the
indoor unit. (Use +Screw Driver)
2) Remove the Drain Pan from the indoor unit.
Ŷ4Way Cassette type(600x600)
To Next Page
Loading...
