Samsung AM036JNVDKH/EU - Troubleshooting; Setting Option Setup Method

Troubleshooting
280 Samsung Electronics
4-3 Troubleshooting
4-3-1 Setting Option Setup Method
4-3-1-1 PCB option code input method
ඖ GG Set the indoor unit address and installation option with remote controller option.
Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting option at the
same time.You need to set twice when setting indoor unit address and installation option.
■ The procedure of setting option
High Temp Button
High Fan Button
Mode change
Low Temp Button
Low Fan Button
Entering mode for
setting option
Option setting mode
Step 1
Entering mode to set option
1. Remove batteries from the remote controller.
2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button
.
3.
Check if you have entered the option setting status.
Step 2
The procedure of option setting
After entering the option setting status, select the option as listed below.
• The total number of available options are 24: SEG1 to SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page options used by the previous remote control models, the modes to set values
for these options are skipped automatically.
• Set a 2-digit value for each option pair in the followinig order: SEG2 and SEG3
ٜG SEG4 and SEG5 ٜG SEG6 and SEG8 ٜG SEG9 and
SEG10 ٜG SEG11 and SEG12 ٜG SEG14 and SEG15 ٜG SEG16 and SEG17 ٜG SEG18 and SEG20 ٜG SEG21 and SEG22 ٜG SEG23 and SEG24.
High Temp Button
High Fan Button
Mode change
Low Temp Button
Low Fan Button
Entering mode for
setting option
Option setting mode
On(SEG1~12) O(SEG13~24)
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
0XXXXX1XXXXX
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2XXXXX3XXXXX