USING THE LONG FUNCTION
Long function will be helpful when you want the cool air to go to much further place.
1. Turn on the air conditioner.
Press the Power button on the remote controller.
2. Set the operation mode.
Press the Turbo/Long button on the remote controller
twice. Long indicator will appear on the remote
controller display.
The air conditioner operates in High fan speed and
automatically adjusts the temperature according to the
current room temperature. The unit operates for
30 minutes and then operates in last used mode, or in
Auto mode if Dry/Fan mode is most recent mode used.
• Long function is only available in Cool/Auto mode.
If Long function is selected in Dry/Fan mode, operation mode changes to Auto.
• When using Long function, the air flow blades face upward and vertical air flow direction
control is not possible.
• You cannot use Turbo and Long function at the same time.
To deactivate Long function
1. Press the Turbo/Long button on the remote controller while Long function is on.
The air conditioner operates in last used mode, or in Auto mode if Dry/Fan mode is most
recent mode used.
• While you are using the remote controller, make sure corresponding indicator appears on
the remote controller display.
• Press Temp or button to adjust desired temperature. Each time you press the
button, the temperature changes by 1°C.
• Fan speed is set as High only and cannot be adjusted in Long function.
• In Long function, air flow can be adjusted in horizontal direction only
(see pages 18~19 for instructions).
To Next Page
Loading...
