E-13
ENGLISH
Cooling Your Room
You must select the Cool mode if you wish to adjust the :
◆ Cooling temperature
◆ Fan speed when cooling
If the is not displayed on the control panel, press the button on the
remote control one or more times until it appears.
Result: ◆ The indoor unit beeps each time you press the button.
◆ The air conditioner runs in the Cool mode.
2
You can change modes at any time.
N
N
o
o
t
t
e
e
To adjust the temperature, press the buttons on the remote control or
buttons on the control panel one or more times until the required temperature is
displayed. Possible temperatures are between 65
O
F( 18
O
C) and 86
O
F (30
O
C ) inclusive.
Result: ◆ Each time you press the buttons:
- The temperature is adjusted by 1
O
F(1
O
C).
- The indoor unit beeps.
◆ The air conditioner starts cooling, provided that the room
temperature is higher than the selected temperature.
◆ If the room temperature reaches the set temperature, the air
conditioner stops cooling, but the fan is still operating.
3
Select the fan speed by pressing the button on the remote control
or button one or more times until the required setting is displayed :
Result:
◆ Each time you press the button, the indoor unit beeps.
Automatic(rotated : ➔➔ )
Low
High
Turbo
4
To control the direction of the air flow, refer to page 20.
5
1
If necessary, press the (On/Off) button.
Result:
◆ The power indicator on the control panel comes on.
◆ The indoor unit beeps.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
◆ Switched on
◆ Stopped
lt will start up normally after three minutes.
IMPORTANT
To Next Page
Loading...
