Before contacting a service centre
Please check the following
The camera doesn't switch on
oThere is low battery capacity
-e Insert fresh batteries. (p.13)
• Battery is inserted incorrectly with the polarities reversed.
-+ Insert the battery according to the polarity marks (+, -).
The camera power ceases while in use
eThe battery is exhausted
--,'. Insert fresh batteries.
oThe Camera is turned off automatically
-e. Turn on the camera power again.
oOperation has ceased in a low temperature outside of the camera
usage temperature range.
-+ Make the camera and battery warm by placing them in your
pocket, etc. and then immediately before shooting, place the
battery in the camera and then shoot.
Camera does not take imaaes whenDressin_ the Shutter button
oThere is insufficient memory capacity
-e Delete unnecessary image files
oThe memory card has not been formatted
-e Format the memory card (p.48)
oThe memory card is exhausted
-e Insert a new memory card
oThe memory card is locked
-e Refer to [Card Locked!] error message
oThe camera's power is off
-e Turn the camera power on
oThe battery is exhausted
-+ Insert fresh batteries (p.13)
• Battery is inserted incorrectly with the polarities reversed.
-+ Insert the battery according to the polarity marks (+, -)
The camera suddenly stopsworkin_while in use
oThe camera stopped due to a malfunction
-+ Remove/re-insert battery and switch the camera on
The imaaes are unclear
oA picture was taken of the subject without setting an appropriate
macro mode
-e Select an appropriate macro mode to take a clear image.
oTaking a picture beyond the flash range
-e Take a picture within the flash range
oThe lens is smudged or dirty
-+ Clean the tens
75
To Next Page
Loading...
