Adjustment and Troubleshooting
Service Manual
4-67
Samsung Electronics
4.2.5 Other Problems
1)Fusing Problems
The fuser consists of the Heat Lamp, Heat Roller, Pressure Roller, Thermistor, and Thermostat.
Error Phenomenon
Low Heat Error In warm-up
- When the Fuser is under 50 for 45 seconds and more
In ready
- When the Fuser is under 130 for 10 seconds and more
In Printing state
- When the Fuser is under 40 of target temperature for 10 seconds and more
Over Heat Error When the set is over 210 for 4 seconds and more
To Next Page
Loading...
