Samsung CLP-610ND - Error Message

Adjustment and Troubleshooting
Service Manual
4-43
Samsung Electronics
4.1.5 Error Message
[yyy]
Cassette Out
[yyy]
Paper Empty
ADC Not
Confirm Error
ADC Slope Error
Cycle Power
Adjusting...
Registration
CTD Calibration
Error
Deve Motor
Locked
Door Open
Duplex Jam 0
Check Inside
Duplex Jam 1
Open/Close Door
Duplex Jam 2
Check Inside
Fuser Fan
Locked
Humidity Open
Cycle Power
Humidity Out
Cycle Power
Inner Temp. Open
Cycle Power
Inner Temp. Short
Cycle Power
Install
Transfer Belt
The tray cassette is not properly closed.
There is no paper in the tray.
There is a problem in the ADC (Analog to
Digital Converter) of your machine.
The temperature slope for ADC (Analog to
Digital Converter) shows the value out of the
normal range.
The machine is adjusting the color registration.
The CTD (Color Toner Density) Calibration
has invalid value.
There is a problem with the deve motor which
moves the toner supply device.
The front cover or the top cover is not
securely latched.
Paper has jammed during duplex printing. It is
applicable only for the machine with this
feature.
Paper has jammed during duplex printing. It is
applicable only for the machine with this
feature.
Paper has jammed during duplex printing. It is
applicable only for the machine with this
feature.
There is a problem with the fan for the fuser
unit.
The humidity exceeds the normal range.
The humidity is fell under the normal range.
The inner temperature of the machine is over
the normal range.
The inner temperature of the machine is
under the normal range.
The transfer belt is not installed.
To close the tray, lower the rear edge align it
with the slot, and slide it into the printer.
Load paper in the tray.
Unplug the power cord and plug it back in.
If the problem persists, contact the service
representatives.
Unplug the power cord and plug it back in.
If the problem persists, contact the service
representatives.
Please, wait a few minutes.
Unplug the power cord and plug it back in.
If the problem persists, contact the service
representatives.
Unplug the power cord and plug it back in.
If the problem persists, contact the service
representatives.
Close the cover until it locks into place.
Clear the jam.
Clear the jam.
Clear the jam.
Unplug the power cord and plug it back in.
If the problem persists, contact the service
representatives.
Unplug the power cord and plug it back in.
If the problem persists, contact the service
representatives.
Unplug the power cord and plug it back in.
If the problem persists, contact the service
representatives.
Unplug the power cord and plug it back in.
If the problem persists, contact the service
representatives.
Unplug the power cord and plug it back in.
If the problem persists, contact the service
representatives.
Install a Samsung-genuine transfer belt.
Message Explanation Solution