Service Manual
Adjustment and Troubleshooting
4-34
Samsung Electronics
Messages (Printer & Engine)
Consumables Life
Toner Low(95%,K(97.5%)) / Replace(100%) / Empty(110%,K(105%))
Replace transfer belt soon(90%) / Replace transfer belt(100%) - 100k
Replace fuser soon(90%) / Replace fuser(100%) - 100k
Replace imaging unit soon(90%) / Replace imaging unit(100%) - 50k (OPC)
Replace Transfer(T2) roller(100%) - 100k
Replace Tray1 Pick-Roller(100%) - 50k
Service call error
Low heat error Cycle power / Over heat error cycle power / LSU motor error cycle power / LSU Hsync error
cycle power / Open Heat error cycle power / Main Motor Locked / Deve Home error / Fuser Fan Locked
Paper
Jam0 / Jam1/ Jam2
TrayPaper Mismatch, Load Manual Press Start Key
Manual Feeder Empty / Tray1 Empty
Etc.
Invalid Black/C/M/Y Toner, Install Black/C/M/Y Toner Door Open, SCF Cover Open, Out-Bin Full, Toner Supply
Error
Special Operation
Low Speed Mode
Objective : To improve toner supply, it lowers the speed sometimes
1. Check the toner level 3 times, consecutively
2. If its level does not satisfy the normal condition, It lowers the speed followed by coverage
Color - 25~49%(1/2), 50 ~74%(1/3), 75%~(1/4)
Mono - 15~24%(1/3), 25~34%(1/4), 35~44%(1/5), 45~54%(1/6), 65~74%(1/8), 75%~(1/9)
Auto Continue
If auto continue set to ON, Printer automatically paper out after 15 sec in paper mismatch state
Altitude
Altitude Adj : It can adjust voltage conditions
To Next Page
Loading...
