Adjustment and Troubleshooting
Service Manual
4-39
Samsung Electronics
Tech Mode Menu
2) EDC Mode
Method to enter
1. After turn on the system power, check the Ready message on the LCD.
2. To enter the EDC Mode, Push the button like next time.
Menu Stop Left arrow Back OK Right arrow
3. The message COMPONENT TEST Press Menu Key display on the LCD.
4. To get out of the EDC Mode, Press the Stop key
EDC Mode Menu
0. Cover Status
Top Cover When a top cover opened, Open message display LCD. If the top cover closed,
Closed message display LCD.
Tray2 Door When a tray2 door opened, Open message display LCD. If the tray2 door closed,
Closed message display LCD.
Item Description
Data Set Counter Reset Fuser You can reset the Fuser Count.
Pickup Tray1 You can reset the Roller-Count of each tray.
Roller Tray2
MP
Margin Top Margin [-10-10]: You can set the Top Margin of all image
(-10mm ~ +10mm)
Left Margin [-10-10]: You can set the Left Margin of all image
(-10mm ~ +10mm)
Report Configuration Printing You can print the configuration report.
Event Log Printing You can print the Event log page. It contains
Jam error, the number of Fuser reset.
To Next Page
Loading...
