Disassembly & Reassembly
12-2 Samsung Electronics
Part Name Description Description Photo
Chassis
Holder
① Separate the Ass'y Holder chassis from the Front Cabinet.
② Pull the Chassis Holder lifting the fixing clip up.
Notice: Pulling the Chassis Holder by force may damage the
clip or the connector. Pull the Chassis Holder just until the clip
comes off the hole.
① Separate the Speakers, the Side AV Wire, the Side Control,
and the Remote Control Sensor Cable from the Front Cabinet
and the System Board.
② Separate the wire from the Wire fixing holder at .
Notice: Since there is a clip to connect the Connector Header
in the Wire Connector, pulling it by force may damage the clip or
the connector. Press the clip down completely and pull the con-
nector.
① Separate the D-Coil and power cable from the Front Cabinet
and Power Board.
② To separate the power cord, slide the fixing clip and lift the
cable up.
① Separate the CRT Ass'y from the CRT
② Separate the TBC wire, GND, VM and Tilt cables from the
CRT Ass'y sequentially.
To Next Page
Loading...
