Disassembly & Reassembly
Samsung Electronics 12-3
Part Name Description Description Photo
CRT
Ass'y
① Separate the cables from the Deflection/System Board and
CRT Ass'y.
① Separate the wires from the FBT of the Deflection Board and
the CRT Ass'y.
② To separate the thick red and white wires, pull the wires while
pressing the push-type clip at the connector.
③ To separate the thin red wire, insert a pin in the small hold
next to the hole and pull the wire.
Notice: Take care when separating the wires because pulling
the wires by force may damage the socket. In addition, separate
the wires on a flat and clean surface so as to prevent scratching
of the material and the PCB.
Part Name Description Description Photo
Chassis
Holder
① Separate the cables connecting the FBT and the CRT.
Notice: Since there may be a remaining high-voltage current
within the CRT, take care not to touch the CRT hole with metal
or a part of yourself when separating the cables.
To Next Page
Loading...
