68
SETUP MODE
POWER OFF
This function switches the camera off after a set amount of time in order to prevent unnecessary
battery drainage.
You can set the power to switch off at any specified time( 1 ~ 10MIN, 1MIN interval) from the last
operation.
If you select [CANCEL], the power off function will not operate.
Note that the automatic power off does not operate if the camera is in slide show or playing a movie
clip.
1. Turn the camera power on.
2. Select the SETUP mode by rotating the mode dial.
3. [SETUP 1/2] menu will be displayed.
4. Press the UP (
)/ DOWN ( ) button and select [POWER
OFF].
5. Press the SET( ) button and the sub menu will be displayed.
6. Select the desired sub menu by pressing the UP( )/ DOWN
( ) button. Press the SET( ) button to confirm the setting.
7. The default is [1 MIN].
INFORMATION
Even if the batteries or AC adapter are removed
and inserted again, the power off setting will be
preserved.
SETUP 1/2
POWER OFF
10 MIN
EXIT:MENU SET:
SETUP 1/2
BEEP ON
POWER OFF 10 MIN
DATE IMPRINT ON
DATE TYPE YMD
CHANGE:
SETUP 1/2
BEEP ON
POWER OFF 10 MIN
DATE IMPRINT ON
DATE TYPE YMD
MOVE PAGE:
To Next Page
Loading...
