117
Starting PC mode
If you connect the USB cable to a USB port on your PC and then turn on the power, the
camera will automatically switch to "computer connection mode".
In this mode, you can download stored images to your PC through the USB cable.
Connecting the camera to a PC
1. In any mode with the exception of Voice Recording
mode, press the MENU button.
2. Press the LEFT/ RIGHT button and select the [Setup]
menu tab.
3. Select the [USB] menu by pressing the UP/ DOWN
button and press the RIGHT button.
4. Use the UP and DOWN buttons to select [Computer],
and then press the OK button.
[Using the USB cable with Cradle]
[Using the USB cable with Camera]
If you selected [Printer] in Step 4, when you connect the camera to your printer, the
[Connecting Printer] message will display and the connection will not be established.
In this case, disconnect the USB cable, and then follow the procedure from Step 2 and
onward.
If you insert the USB cable without inserting a memory card, [No Card!] message will display
and the camera is turned off. Please insert a memory card before inserting the USB cable.
Back: Set : OK
Imprint
Sound Computer
USB Printer
NOR
Setup
To Next Page
Loading...
